IBR-TOUCH & IBR-TOUCH-WL Quick Start Guide
3
14
Upon connection to the Internet-based account for
either the
StarLink Connect
radio or the
iBridge
(zRemote) Z-Wave Controller, the resulting keypad
shown in step 15 will be configured for the pay-
ment plan selected by the customer. For example,
smart phone notifications and camera video.
13
The IBR-TOUCH / IBR-TOUCH-WL will automati-
cally attempt to connect, through the "cloud", to
either the NAPCO
StarLink Connect
radio ac-
count or the NAPCO
iBridge
(zRemote) Z-Wave
Controller account. Enter your administrator ac-
count
User ID
and
Password
and tap
Finish
.
15
Be sure to verify the touchscreen display reflects
the current status of the security control panel.
Note:
The red text at the bottom right de-
scribes the connections; the model IBR-TOUCH
is shown in this example, with its wired connec-
tion to the security control panel 4-wire bus, and
its Wi-Fi connection to the StarLink Connect ra-
dio or IBR-ZREMOTE.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna;
-- Increase the separation between the equipment and receiver;
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
The distance between user and products should be no less than 20cm.
