IBR-TOUCH & IBR-TOUCH-WL Quick Start Guide
1
© NAPCO 2018
WI2297LF
preliminary draft # .25
4/18
NAPCO iBridge
™
IBR-TOUCH &
IBR-TOUCH-WL Touchscreen Tablets
1
Unpack the touchscreen tablet
(
look carefully for the sup-
plied mounting hardware; the Power Adapter is only included with
the model
IBR-TOUCH-WL
)
Note:
If using older ISEE Series Cameras, use your existing
ISEE-WAP (with its power adapter and CAT5 cable, shown).
IBR-TOUCH-WL
Touchscreen
Rear Case
2
Mount the touchscreen rear case to the wall using
screws appropriate for the mounting surface.
Power must be provided with the
IBR-TOUCH-WL
using the 12VDC power adapter, observing polarity
(use the wire hole located in the center of the rear
case, shown below). The
IBR-TOUCH
connects
to the Gemini security system 4-wire bus.
3
Apply power to the control panel, the touchscreen
and the ISEE-WAP / IBR-ZREMOTE / StarLink
Connect radio. Upon power up, both touchscreens
will start within about 5 seconds (both can be manu-
ally powered by pressing and holding the small but-
ton on the right side for 10 seconds).
4
Upon power up, the
Setup Wizard
will automatically
start. Follow the sequence of images as shown in the
following steps, as necessary for the in-
stallation type.
If the
Setup Wizard
does
not automatically start, press and hold
the
System Settings
("gear") icon, enter
your Dealer password, then tap
Setup
Wizard
.
"center hole" for
power or keypad bus
wires
CAT5 Cable
ISEE-WAP
Power Adapter
Power Adapter
Tap
Yes
and set the date, time and Time Zone (if
necessary).
IMPORTANT:
Outdated digital certifi-
cates will disallow connection to your iBridge or
StarLink Connect system, as well as inhibiting nec-
essary automatic firmware downloads.
5
Wait for the system diagnostics process to complete.
Functional components are marked with a check;
items not configured or not enabled are marked with
a "x". Selections are blank when the
Setup Wizard
is
run for the first time. Tap
Configure
to continue.
6
. .
System Settings
button
QUICK START GUIDE
