Napa 85-8100, Instruction Manual

Page: 9 / 56

▪ ▪
7. CHARGER FEATURES AND CONTROLS
The NAPA 85-8100 Wheel Charger is a fully functional wheel charger with a unique digital inter-
face module that allows users to perform battery charge acceptance, starter, and alternator tests.
7.1 CONTROL CENTER FEATURES
VOLTS
AMP-HRS.
AMPS.
TIME
TEMPS
TIEMPO
TEST / PRUEBA
OK
CHARGE CARG
A
SELECT
SÉLECT.
SELEC.
FUNCTION
FONCTION
FUNCTIÓN
BAT. START. ALT.
V
A
Ah
PASS
FAIL
The Select button gives
the user the ability to
select the display out-
puts, depending on what
is desired.
The Function button
allows users to change
the operation from
Charging to test modes
(Battery Charge
Acceptance, Starter, or
Alternator test).
The Digital Test and
Charge display module
displays volts, amps, amp
hours, and charge time
units as indicated via
green LEDs.
pass/Fail lEDs indicate
test results via a green
LED for PASS and a
red LED for FAIL.
Control Center Panel
Multi-purpose numerical lED display
functions as Voltmeter, Ammeter, Amp
Hour Accumulator, and Timer.
NOTE: The multi-purpose LED display changes function according to how the charger is being used:
As an AMMETER, it indicates the amount of amps flowing from charger into battery.
It keeps track of all accumulated amp hours during a test.
It serves as a
VOLTMETER , indicating live voltage as soon as clamps are attached.
During TIMER operations, it shows either remaining time or elapsed time.
HOLD
CONT.
ESPERA
OFF
ARRÊT
APAGADA
30 MIN
45 MIN
15 MIN
60 MIN
75 MIN
90 MIN
105 MIN
120 MIN
PRUEBA
TEST
7.2 TIMER SWITCH
The Timer switch on the upper-right turns ON
the charger by setting a time. This must be done
before the charger is plugged in.
The
OFF
position disconnects the output of the
charger. By rotating the dial clockwise the output
is turned ON for a duration of time determined
by the number of minutes at which the dial is set.
The HOLD function can be used if charging times
longer than 120 minutes are required. While in the
timing phase, the output can be turned off by rotat-
ing the dial counterclockwise to the OFF position.
Timer Switch
When determining charging time, refer to section 12 . If the charger is plugged in when the Timer is
set, the internal fan will spin. A faint ticking sound is heard while the Timer runs.
NOTE: There is no sound when the Timer completes, except for a soft click.