Naomi Home Cyra, Assembly Instructions Manual

Page: 16 / 17

Electrical and Moving Parts:
The fan motors are lubricated at the factory and will not require lubrication.
Electrical components are integrated in the fireplace and are not serviceable by the consumer.
Storage:
Store heater in a clean dry place when not in use.
WARNING! No other servicing should be performed by the consumer. Do not attempt to
service the unit yourself.
WARNING
DISCONNECT THE APPLIANCE COMPLETELY AND LET COOL PRIOR TO ANY SERVICE.
ONLY A QUALIFIED SE VICE PERSON SHOULD SERVICE AND EPAIR THIS ELECTRIC APPL A I NCE.



R R
MAINTENANCE & TROUBLESHOOTING
TROUBLESHOOTING
1. Fireplace turns off and will not
turn on.
2. Flame is not moving
1. Loose Wiring
2. Flame motor defective
3. Flame rod out of place
3. Flame is not visible
4. Log set and / or crystal is not
glowing
5. Remote control does not work
1. Wiring is loose
1. Wiring is loose
2. Color / Brightness is off mode
1. Low batteries
2. Not aiming remote at unit correctly
3. Defective remote control and/or
sensor
Page 16 of 17
1. Fireplace has overheated and safety
device has caused thermal switch to
disconnect or circuit breaker has
tripped
PROBLEM POSSIBLE CAUSE SOLUTION
1. Reset switch by turning main POWER
OFF, wait 5 minutes, check for blockage,
power ON or check circuit breaker
1. Inspect wiring for loose connections.
2. Call a qualified service technician to
replace flame motor.
3. “Flame Rod” out of alignment due to
rough transit / handling of appliance.
This issue can be corrected by removing
the glass, turning the fireplace upside
down, remove a set of screw holding
the bottom frame plate and placing
the flame rod back into place.
1. Disconnect from power source
and inspect wiring for loose
connections and repair or replace
if necessary.
2. Press the flame button to high
1. Disconnect from power source
and inspect wiring for loose
connections and repair or replace
if necessary.
1. Replace AAA batteries in remote
control.
2. Aim control at sensor located
directly behind glass screen in
center of unit just above logs.
3. Replace remote control and/or
sensor.