4.1 Fans in the case front
To switch the fans in the front or to clean the dust filters, please remove the front panel by
holding the cutout at the bottom and pull it towards you with a firm tug.
Next, remove the four screws with which the dust filter is connected to the front and take
it out.
Please be advised that the fans are screwed to the dust filter.
The front dust filter allows the installation of either 2 x 120 mm or 1 x 140 mm fans.
Two 120 mm Deep Silence fans (1.300 rpm) are preinstalled.
4.2 Fans under the top cover
If you want to install additional fans at the top of the case, please remove the Nanoxia
VentCovers first by removing the screws on the outside of the case. Next, hold the fans from
the inside and secure them to the top by fastening the screws from the outside.
Case fans installed at the top of the case should exhaust air out of the case (fan rear side
facing outwards).
4.3 Fans at the bottom of the case
If you want to mount a 120 or 140 mm fan on
the case bottom, you must remove the hard
drive cage mounting located at the bottom.
The rail is attached with four screws to the
bottom.
07
Summary of Contents for Deep Silence 3
Page 1: ......
