5.3 Fan at the bottom of the case
If you want to mount a 120 or 140 mm fan at the case bottom, you must remove the secondary
hard drive cage mounting rail located at the bottom. The rail is attached with four screws to
the bottom.
Please place the fan on the inside of the case and secure it from the outside.
The dust filter at the bottom can be pulled out for easy cleaning.
An additional case fan at the bottom of the case should be mounted so that cooler air is
introduced into the case (fan rear side facing inwards).
5.4 Fan in the side panel
If you want to accommodate a fan in the side
panel, remove the outer cover by loosening
the screws on the inside. The dust filter can
remain in its position.
Please place the fan on the inside of the
side panel above the dust filter and secure it
from the outside.
If you secure the cover in the side panel again after the removal of a side fan, please make
sure not to tighten the screws not too much. To avoid damage to the internal thread or the
side panel, the screws should be tightened by hand only.
12
Summary of Contents for Deep Silence 1 Revision B
Page 1: ......
Page 19: ... Nanoxia 2015 ...
