Technisches Handbuch
SMCI33
Connection and commissioning
8
Issue: V 2.2
2.2 Commissioning
Introduction
The connection and commissioning of the SMCI33 stepper motor are described
below.
This section describes the main first steps you need to take to be able to quickly begin
working with the SMCI33 if you are using the NanoPro software from a PC. You will
find more detailed information in the separate NanoPro manual.
If you want to work at a later time with a PLC or your own program, you will find the
necessary information in the separate "Command Reference".
Familiarize yourself with the SMCI33 stepper motor control and the corresponding
NanoPro control software before you configure the controller for your application.
Procedure
Proceed as follows to commission the controller:
Step Action
Note
1
Install the NanoPro control software on your PC.
See the NanoPro separate manual.
Download of
www.nanotec.com
2
Connect the controller to the stepper motor
according to the connection diagram.
Connection diagram, see
Section 2.1.
Detailed information on
connections can be found
in Chapter 3.
3
Switch on the operating voltage
(24 V DC ... 48 V DC).
The green LED lights up.
4
If necessary, install the USB driver and the
driver for the converter cable ZK-RS485-USB.
Download
www.nanotec.com
in the
Support/Download/Driver
menu item
5
CAUTION!
Danger of overvoltage at the USB interface.
When using notebooks connected to the line
supply, detach the power cable before
connecting the USB cable.
6
Connect the controller with your PC.
Use one of the following converter cables for this
purpose:
•
ZK-RS485-RS232 for connection to the serial
interface
•
ZK-RS485-USB or conventional USB cable,
type MINI-B, for connecting to the USB
interface (for SMCI33-1)
Order number:
•
ZK-RS485-RS232
•
ZK-RS485-USB
