EZ-Tear Thermal Printer
Owner’s Manual
1.7 Testing the Printer
Run this test to check the printer. The test prints a resident test ticket. Verify this ticket to
judge the printing quality. This is an example, the printer’s actual status and associated
printout will vary depending upon the configuration shipped to you.
Model: EZ
tear
Firmware: TI3-XXXXXXXXX
COMMUNICATION
Interface:
IEEE1284 (0) or Serial
Baud: 9600
Data Bits:
8
Parity: NONE
Handshaking: NONE
Print Mode:
NTL
Aux Port:
Disabled
PRINT CONTROL
Darkness Control:
-1%
Voltage: 24.2
Volts
Temperature: 26
Celcius
Speed: 4
IPS
Black Bar Index:
Disabled
SYSTEM RESOURCES
FLASH -Used:
0
-Free:
24576
LIBRARY INVENTORY
Templates: 0,1,2
Print Regions:
1,2,3,4,5,6,7,8,
h,9,A,B,C,D,E,F,G,
I,J,K,L,N,O,P,Q,R,
S,T,U,Z,X,a,b,c,d,
e,f,g,i,j,k,l,m,n,
o,p,q,
Graphics: None
Fonts: 0,3,5,7,8
MANUFACTURING INFORMATION
Printer ID:
5465789
Date Code:
20184
PWM Setting: 7F7F7F7FFFFFFF
A to D:
DE7AA400FD000000
Resets: 9
Tickets: 00001336
Status: TI3-XXXX- 0-40-40-40-40-P
Figure 6: Test Ticket
To print the test ticket, power-on the printer while pressing and holding the Paper Feed
Button for approximately 6 seconds. A test ticket similar to above will be printed
approximately 5 seconds after. Press the paper feed button once more and the ticket
will feed. Pressing the button again will result in blank tickets.
102136
July, 2005
8
