Fit the inlet block to your chosen side using
the screws provided. (Extra blocks can be
purchased if required.)
2
3
4
Insert the large blanking plug into the
remaining unused port block located on the
opposite side of the unit.
Lower the fi lter bag 1 into the separator
body, se ling it down gently, and ensuring it
is in contact with the side wall.
Lower the fi lter bag 2 into the separator
body, se ling it down gently on top of
fi lter bag 1.
5
6
7
Install the securing spring clips at 90
degrees directly in contact with the fi lter
bags to prevent fl oata on.
Insert the second fi lter (needle-felt bag with
black inlet tube) and rest it on top of the
retainers.
Screw the inlet connector (reducing
bushing) into place ghtly.
8
9
10
Connect the fi lter tube to the inlet block
using the fi ngs supplied.
A ach the twist off grab tap to the test point.
A ach your outlet hose to the nipple above. Fill
unit with water and check for leaks.
11
Assemble and a ach the service life
indicator to the lid of the unit using the
pre-drilled hole.
copyright PURIFICATION SOLUTIONS LLC
publication reference n-psi-S1-SEP1250ST-02-us
tel:
704.897.2182
email: [email protected]
www.n-psi.com
