Nanni T4.155 seriers, Workshop Manual

Page: 191 / 191

60300140 (
indice A
) 4 CYLINDERS WORKSHOP MANUAL 191/191
POST-ASSEMBLY
1. REINSTALL THE PLUG
2. REINSTALL THE MOTOR SUSPENSION
ATTACHMENT PLATE
3. REINSTALL THE WATER TEMPERATURE SENSOR
4. REINSTALL THE THERMOSTAT AND THE WATER
INTAKE PIPES
5. REINSTALL THE OIL RADIATORS
6. REINSTALL THE ENGINE LOWER CASING AND
THE TIMING GEAR CASING (OIL PUMP)
7. REINSTALL THE INJECTION PUMP
8. REINSTALL THE TIMING GEARS
9. REINSTALL THE WATER PUMP
10. REINSTALL THE ALTERNATOR AND THE
ALTERNATOR ATTACHMENT PLATES
11. REINSTALL THE CYLINDER HEAD
12. REINSTALL THE TIMING BELT AND THE TIMING
PULLEYS
13. REMOVE THE COMPLETE ENGINE FROM THE
ENGINE TEST BENCH
14. REINSTALL THE REAR CLOSING PLATE
Reinstall the rear closing plate with its assembly bolt.
Recommended tightening torque: 8 N.m (85 kgf.cm)
15. REINSTALL THE ENGINE FLY WHEEL
a. Coat the threading of the cylinder head bolts over two or three
threads with the sealant.
b. Reinstall the fly wheel on the crankshaft.
c. Reinstall and evenly tighten the assembly bolts to the
recommended tightening torque in several stages and in the
order indicated in the illustration.
Recommended tightening torque:
145 N.m (1,480 kgf.cm)
16. REINSTALL THE CLUTCH CLOSING PLATE AND
THE DISK