Nanni N16.900 CR3, Operator'S Manual

Page: 64 / 119

64
LUBRICATION SYSTEM
OILS
NOTE !
For more information about lubricants, please refer to
the Fluids Section.
CHECKING THE OIL LEVEL
NOTE !
Leave the engine off for at least 7 minutes before you
check the oil level.
1. Pull out the oil dipstick (1) and check the oil level. The
correct level is between the minimum and maximum
marks on the oil dipstick.
2. Fill with more oil via the oil filler (2) if the oil level is at
or below the minimum mark.
CHANGING THE OIL
NOTE !
Change oil more often if the engine is subjected to par-
ticularly demanding operation, such as a dusty envi-
ronment, or if deposits in the centrifugal oil cleaner are
thicker than 28 mm (1.1 in). Renew the oil filter and clean
the centrifugal oil cleaner when changing oil.
ENVIRONMENT
Use a suitable container. Used oil must be disposed of
as specified in national and international laws and reg -
ulations.
1. Unscrew the oil plug and drain the oil when the engine
is hot. In certain engines, the oil is pumped out using a
bilge pump. When draining via the valve, the oil should
be hot. Alternatively, use a pump. This is so that draining
occurs more quickly.
2. Clean the magnet on the oil plug.
3. Refit the oil plug.
4. Fill with oil.
5. Check the level on the oil dipstick.
S08 MAINTENANCE