5
Remote Control and Control Method by Wire Controller
·
PavoBulb 10C supports DMX, 2.4G and wire controller control, and includes a built-in Bluetooth as well.
▲Address code need to be pre-set for DMX and 2.4G control.
1. Address setting
The address code of the fixture can be set by connecting DMX/RDM console, wire controller or by APP via the
transmitter box. (For specific operations, please refer to the relevant manuals.)
2. DMX Remote Control
①
Connect the fixture to the DMX/RDM console with a DMX adapter cable.
·
The connection between the fixture and DMX adapter cable is as follows:
·
The connection between light fixtures, or light fixture and DMX/RDM console should use DMX adapter cable.
(DMX adapter cable is not included.)
XLR plug/socket and the wire should be connected as shown above.
·
Pin1, Pin2, Pin3 for connecting DMX signal. Pin4, Pin5 has no connection.
▲NOTE: When connecting DMX, make sure the internal pin is not in contact with the inner case. The fixture can
match the DMX512 (1990) control signal.
GND 1
DATA- 2
DATA+ 3
NC
NC
DMX IN
1 GND
2 DATA-
3 DATA+
NC
NC
DMX OUT
