Shanghai Nanhua Electronics Co., Ltd Tel
：+86 021-39126868
Fax
：+86 021-39126868ext 808/818
Web
：
www.nanhua.com
E-mail：
Add: Building 9, No.
1755Wenbei Rd, Jiading district Shanghai 201802
All rights reserved by Nanhua,
without the written authorization of the Nanhua, any part thereof shall not be reproduced or transmitted in any form.
FR15 Synchronizing Control Box
FR15-E3-V12
2 /
3
Accessory：photocell
PJ003
Inside picture
Application
switch to the right side, control box is in manual status. In this case, the lights will be off.
••
Steady burning/flashing mode switchover, and flashing rate setting:
DC type:
Set it by dial switch. When 2 dial switch is in “ON” status, aviation light is steady burning.
Otherwise, aviation light is flashing. Flashing rate 20\40\60 FPM is optional. Please see
following diagram:（FPM = FLASH PER MINUTE）
AC type:
The 4 dial switches on the left side control 1-4 aviation light separately.
When dial switch is in “ON” status, aviation light is flashing. When dial switch is in “OFF”
status (digital), aviation light is steady burning.
Flashing rate could be 20/30/40/60 FPM, please see following diagram:
• GPS synchronization function(AC110V~AC240V optional ):
GPS synchronization is against aviation lights under control box (flashing mode) managing.
Meanwhile, all control boxes must be same flashing rate setting. It will receive signal
successfully after 10 minutes operation.
GPS antenna must be installed in open environment.
• Installation：
DC type control box：
Single channel to control aviation light flashing/steady burning is not available.
Recommendation: when control box connect different types of aviation light under steady
burning mode, the work mode should be controlled by aviation light. Or the steady burning
lights are controlled by control box and make them flashing.
AC type control box:
Single channel to control aviation light flashing/steady burning is available.
We recommend using steady burning lights. Flashing/steady burning is controlled by
control box.
We do not recommend using flashing lights. It my output alarm by mistake.
