5
Attention!
INSTALLATION AND COMMISSIONING
8.The float switch must be clamped at the card line so that it
can normally float, control, turn on and off. This should be
checked, and the floating ball switch should be carefully picked
up and put down again. When you do this, pay attention to the
switching status of the switch.
9.Ensure the distance between the top of the floating switch
and switch line card buckle is not too small. If the distance is
too small, it cannot guarantee normal work.
10.When you set up the float switch, make sure that the switch
does not touch the base before the pump is opened. Warning:
There is a risk of dry running.
Risk for equipment damage!
Do not lift the pump by cable or pressure hose,be-
cause these cables or pressure hoses are not
designed for tensile strength from pump weight.
The float switch must be able to move freely and the
submersible pump cannot be used in a dry environ-
ment.
Attention:
For rope handling: Do not operate the pump without
the pressure hose to prevent the pump from twist-
ing around its longitudinal axis. In continuous use
of a pump with a rope, the condition of the rope
must be checked periodically, as it may break with
increasing use time.
