Nakayama PS3000, Owner'S Manual

Page: 39 / 58

www.NakayamaTools.com
NOTE
！
The oil reservoir has a capacity sufficient to provide about 40 minutes of cutting time
(when set to deliver the minimum flow rate, or about as long as you’ll get from a tank of
fuel). Be sure to refill the oil tank every time when refuelling the saw.
ADJUSTING OIL FOW RATE
WARNING
！
Never fill the oil reservoir nor adjust the oiler with the engine running.
An increase in bar oil flow rate will speed oil consumption, requiring more
frequent checks on the oil reservoir. To ensure sufficient lubrication, it may be
necessary to check the oil level more frequently than at fuel tank refills.
The guide bar and chain are lubricated automatically by a pump that operates whenever the chain
rotates. The pump is set at the factory to deliver a minimum flow rate, but it can be adjusted in the
field. A temporary increase in oil flow is often desirable when cutting things like hardwood or wood
with a lot of pitch.
Adjust the pump as follows:
1. Stop the engine and make sure the stop switch is in the OFF position.
2. Place the unit on its side with the oil reservoir up.
3. With a screwdriver, push in on the oil flow rate adjusting screw and turn in the
desired direction
IMPORTANT
！
The oil flow adjusting screw must be pressed in slightly in order to turn. Failure
to do so could damage the pump and screw.
OPERATION- POLE HEDGE TRIMMER:
WARNING!
This product is equipped with extremely sharp blades, and when used improperly
these blades can be extremely dangerous and improper handling can cause
accidents, which may in turn lead to serious injury or death. For this reason, you
should always be careful to follow the following instructions when using your
trimmer.
max
min