Nakayama MB5005, Manual

Page: 7 / 23

EN
Cutting height setting
Shifting the depth limiter shall set up the required depth
of tilling. 3 different positions are possible .
Switching unit on/off
Set the lever to the choke position (Fig . 15 ). Pull the
starter cable evenly. The engine should start up after 3-5
pulls. Set the lever to the required speed setting and pull
the driving lever (Fig. 16) against the handle.
Notice: If the engine is heated up, it is possible to start up
in the slow/fast position.
With the driving lever tripped, the drive will be off but the
engine will still be on . The engine may be switched off
with the switch in OFF position (Fig. 15 )
Operator s afety i nstruction s
* Do not use the machine until you have read the instruction manual carefully.
* Observe all safety instruction s included in the manual.
* Be especially careful while operating the machine when other persons are nearby.
* The unit is equipped with a foot-operated brake than stops the blades within 3 seconds after the drive lever trip s . Never
attempt to stop or tilt the unit with the blades still rotating. Wait for the blades to completely stop rotating.
* If the blades come into contact with foreign objects, stop the engine immediately , wait for the blades to completely stop
rotating and check the unit for damage. Continue working only if no damage is detected on the unit.
* Walk while working and do not run.
* Always walk forward only. Never pull the unit walking backwards.
* When working on a slope, always work across, never down and up. Be particularly careful when changing direction.
* When travelling across no-grass areas and transferring the unit from the work area to another one, the blades must not be
operating.
Step-by- s tep i nstructions
1. Fill in the fuel (see chapter ''Assembly and first time operation'' )
2. Clear any foreign objects from the land.
3. Spud the land until the soil is sufficiently loose.
4. Clean the unit thoroughly after every use.
WWW.NIKOLAOUTOOLS.GR
7
Fig . 14
Fig . 15
Fig . 16