EN
WWW.NAKAYAMATOOLS.COM
6
Replace the spool of nylon line (see figure)
Remove the spool assembly from the trimmer. To do so, hold the outer ribbed part of the
assembly with one hand, while pushing down and turning the spool head with the other
to unlock it. The spool carrier and spool will now disassemble easily.
Note:
Inside the spool that could easily be lost. Ensure that it is put in a safe place.
Insert the line through the eyelet in the spool carrier and slide the spool into it.
Making sure to assemble the spool and spool carrier back onto the trimmer. To do so, push the spool cover until it locks.
To test if the line is advancing properly, push the button with your thumbs while pulling the wire with your fingers. The line
should advance freely.
Note:
use only manufacturer’s recommended replacement spool
Maintenance And Storage
a) Keep all nuts, bolts and screws tight to be sure the equipment as a safe working conditions.
b) Allow the engine to cool before storing in any enclosure.
c) To reduce the fire hazard, keep the engine storage area free of grass, leaves or excessive grease.
d) Replace worn or damaged parts.
e) Use only manufacturer-recommended replacement parts and accessories.
f) Never clean or spray a machine with water. Clean the motor housing only with a moist cloth and never use detergents or
solvents! These could ruin the plastic parts of the machine. Finally, dry the motor housing carefully.
g) Store the machine with the supplied protection cover.
Technical Data
Voltage/Frequency:
230V-50Hz
Input Power:
550W
No Load Speed:
10000Rpm
Cutting Capacity:
300Mm
Line Size:
Ø1.6mm x 300 mm
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes signif
-
icantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also
concern other models of the manufacturer’s product line with similar features and may not be included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is
used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
Summary of Contents for ET6000
