Nakayama EB9000, Operating Instructions Manual

Page: 12 / 23

12
6.2 Installing/replacing the line spool(B4, B5-
1, B5-2)
The procedure for fitting the line spool(11) is
shown in Figure . To dismantle, proceed in reverse
order. The line spool is already fitted when the
equipment is delivered.
Look for the hole in the carrier plate(15), line up
with the notch beneath it, lock with the supplied
hex wrench , and screw the line spool onto the
thread.
6.3 Fitting/Replacing the cutting
blade(B6-B9)
- Fit the carrier plate (15) onto the spline shaft
- Secure the cutting blade(12) on the inner plate
- Place the outer plate(16) over the cutting blade
- Use nut (18) to tighten the plate and the cutting
blade with the plug wrench (19).
6.4 Fitting the long handle(B2-1,B2-2,B2-3)
Pass the handle screw (6) through the washer (15)
and into the connecting piece of the long handle.
Secure the handle screw loosely with the screw
(6).
6.5 Install assistant handle.(B10-1,B10-
2,B10-3)
- Unscrew the screw on the additional handle
included in delivery
- Pull the ends of the additional handle apart and
push this over the handle holder
- Screw on the additional handle with the screw
7. Operation
Warning: Danger of injury!
Never use the trimmer without its protective
cover. Always check the operability of the
trimmer before it is used. Check that the mains
voltage is the same as indicated on the rating
plate. Always wear goggeles when working
with the trimmer.
7.1 ON and OFF Switch
To switch on depress the ON/ OFF switch(2).
Release the switch to switch off.
Important! After the trimmer has been switched
off the cutting head will continue to rotate for a
few seconds. Keep hands and feet well away.
7.2 Adjusting the additional handle:
The additional handle(5) can be set in different
positions. Set the handle in such a manner that
the cutting head is slightly tilting forwards when
in the working position.
Release the knurled nut and adjust the additional
handle in the required position. Retighten the
knurled nut.
7.3 Lengthening the cutting lines
7.3.1 Fully automatic dual line system
The equipment features a fully automatic dual
line system.
The lines will automatically elongate every time
you turn on the appliance. To support proper
line elongation, ensure that the coil has stopped
moving completely before turning on the
appliance again.
If the lines should be longer that defined by the
cutting circle then they will be automatically
cut to the correct length by the line cutter.
Important! Regularly check the nylon lines for
damage and whether the lines still have the
correct length defined by the line cutter.
7.3.2 Adjusting the line length manually
Disconnect the plug from the mains socket!
Press the retaining head, release it again and
pull the ends of the cord out a little. Repeat this
process until the ends of the cord project a little