Nakayama 032342, Manual

Page: 9 / 19

EN
WWW.NAKAYAMATOOLS.COM
4
and make repairs before restarting and operating the lawnmower. If lawnmower
starts to vibrate abnormally (check immediately):
- Inspect for damage.
- Replace or repair any damage parts. - Check
for and tighten any loose parts.
25) Stop the mower:
- Whenever you leave the lawnmower:
26) keep all nuts, blots and screws tight to be sure the equipment is in safe working condition;
27) check the grass catcher frequently for wear or deterioration;
28) Replace worn or damaged parts for safety;
29) No to use the lawnmower if the cords are damaged or worn
30) Not to connect a damaged cord to the supply or touch a damaged cord before it is disconnected from the supply. A
damaged cord can lead to contact with live parts.
31) Not to touch the blade before the machine is disconnected form the supply and the blade have come to a complete stop
32) To keep extension cords away from the blade. The blade can cause damage to the cords and lead to contact with live
parts.
33) To disconnect the supply (i.e. pulling the plug from the socket):
- Whenever leaving the machine unattended.
- Before clearing a blockage.
- Before checking, cleaning or working on the machine. - After
striking a foreign object.
- Whenever the machine starts vibrating abnormally.
34) Children are not allowed to use the machine.
35) This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their
safety.
36) If the external flexible cable or cord is damaged, it shall be exclusively replaced by the manufacturer or his service agent
or a similar qualified person in order to avoid a hazard (not light than H05VV-F 2x1.0mm2)
37) instructions for the safe operation of the appliance, including a recommendation that the appliance should be supplied
via a Residual Current Device (RCD) with a tripping current of not more than 30 mA.
38) Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts
of the machine.
39) Always allow the machine to cool before storing.
40) When servicing the blades be aware that, even though the power source is switched off, the blades can still be moved.
41) Replace worn or damaged parts for safety; Use only genuine replacement parts and accessories.
42) Be careful during adjustment of the appliance to prevent entrapment of the fingers between moving blades and fixed
parts of appliance.
43) If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.