6
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
INFLATING THE WING
A) Lay the wing fl at on the ground (upside down) with the strut facing up. Make sure the leading edge
is facing toward the wind.
B) Attach the pump leash to the leash connection point on the leading edge.
C) Push button in and turn approximately 90 degrees until it springs out.
D) Insert the pump hose end piece and infl ate until you reach the required pressure. If the wing has
been stored upright, you will want to grab the second handle at the strut after infl ating the leading
edge and shake slightly, allowing the strut bladder to fall back in place toward the leading edge.
E) Using a Naish pump with gauge, infl ate the wing to the recommended psi:
sizes: 2.2/2.8/3.6: 8-10 psi, sizes: 4.6/5.3: 7-9 psi, sizes: 6.0/6.8 : 6-8 psi
F) Remove pump nozzle from SureLock Valve and tighten the cap by turning it clockwise to the
closed position.
G) Close the velcro cover over the SureLock Valve.
VALVE DIAGRAM DETAIL
A) Valve Cap
B) Button
C) Valve Base
A
E
C
G
B
F
D
A
B
C
