NAiS GT10, Technical Manual

Page: 3 / 195

ii
How This Manual Is Configured
GT10/GT30 Main Unit
Before Using the GT series
This section describes items that should be confirmed and precautions that should
be observed before the GT series are used.
Chapter 1. Specifications
This chapter contains the names and specifications of the various parts of the GT se-
ries, as well as a table of functions, wiring diagrams, and dimensions.
Chapter 2. Installation and Wiring
This chapter explains how the GT series should be installed and how wiring should be
connected.
Chapter 3. Setup
This chapter describes the setup procedures necessary when using the GT series for
the first time.
Chapter 4. Connecting and Communicating with the PLC
This chapter explains how to connect the GT series to the PLC and the FP series by
Matsushita, and how to set up communications between the units.
Chapter 5. GT10 Configuration Settings
This chapter describes the configuration settings for the GT10, and how they should
be entered.
Chapter 6. GT30 Configuration Settings
This chapter describes the configuration settings for the GT30, and how they should
be entered.
Chapter 7. How the Various Functions Are Used
Functions such as switching GT series screens, backlighting, and buzzer control are
explained here.
Chapter 8. Servicing and Maintenance
This chapter describes servicing and maintenance procedures for the GT series, as
well as how optional items are handled.
Chapter 9. Troubleshooting
This explains what to do if there appears to be something wrong with the GT series,
or an error occurs.
Screen Creation Tool Terminal GTWIN
Before Using Terminal GTWIN
This section contains special precautions that should be read if you are using GTWIN.
Chapter 10. Preparing GTWIN
This section explains how to install GTWIN in the personal computer, how to boot it,
and how to exit it.