Nagel FOLDNAK M2, Manual

Page: 12 / 36

12
Troubleshooting
Machine is switched on, but the light inside the ON/OFF-Selector (7) is not on
The power cord is plugged in improperly: Push power cord thoroughly into power
outlet.
Circuit braker has been activated: Push circuit braker button in again. It is
located at the machine’s rear, beneath the
power cord outlet.
Internal problem: Contact your dealer.
Button „START“ (6) is being pushed, but machine does not work
Cover (5) is open:
Close cover.
Staple jam inside staple channel: Take off stapling head, remove both
screws of front plate (18), take off front
plate. Remove jammed staple, clean stap-
le channel and reassemble.
Jam of the moving parts because too
much paper has been inserted: Push button „RESET“ (9) for a few sec-
onds. The machine then runs backwards,
enabling the operator to pull out jammed
paper.
Circuit braker has been activated: Push circuit braker button in again. It is
located at the machine’s rear, beneath the
power cord outlet.
Internal problem: Contact your dealer.
Machine does not staple although the staple magazine is filled
Driver blade (16) is not hinged onto pin
(17):
Hinge hole of the driver blade (16) onto
pin (17).
Driver blade (16) is missing: Put in a driver blade. The mark „26“ must
show towards the rear side of the ma-
chine.
Staple jam inside staple magazine: Use original NAGEL-Staples and make
sure to only use types 26/6 or Ri 26/6.
Staple pusher (12) does not push staples: Push staple pusher gently down to unlock
and guide it towards the staples.
Staple jam inside staple channel: Take off stapling head, remove both
screws of front plate (18), take off front
plate. Remove jammed staple, clean sta-
ple channel and reassemble. Use only ori-
ginal NAGEL-Staples and make sure to
only use types 26/6 or Ri 26/6.