Microphone Connection (using the UB-10 transmitter with either a
headworn or lavalier microphone or the UH-10 handheld microphone
transmitter)
For microphone use, either the
BALANCED MIC AUDIO OUTPUT XLR (11)
or the 1/4" line level
AUX AUDIO OUTPUT (10)
can be used.
The XLR output is set at a non-adjustable microphone level, similar to
hardwired mic levels. Plug an XLR connector into the XLR output socket on
the rear of the unit and plug the other end into your amplifier or mixing
board. Make sure the phantom power on your mixing board is turned off
and the volume is turned down when making connections. For your
convenience, the XLR output level is preset at the factory and is not
adjustable with the receiver volume control.
To use the 1/4"
AUX AUDIO OUTPUT
socket, follow the instructions for
the Instrument Connection (above), except start the receiver volume at
1/2 MAX and adjust until the volume level is optimal. If the volume
control is set too high, you may overload your mixer or amp.
The UHF 10 receiver is equipped with an
AF PEAK LED INDICATOR (3)
which lights with a strong audio signal from the transmitter. Occasional
flickering on loud inputs to the transmitter is normal. If the LED lights
continuously, decrease the volume to the transmitter or overload distor-
tion may result.
1. Unscrew the
BATTERY COMPARTMENT COVER (13)
and remove,
exposing the
BATTERY HOLDER (14)
. Insert a fresh
9V ALKALINE
BATTERY (15)
, observing the correct polarity as marked, and screw the
cover back on to the microphone. Make sure the cover is screwed on
completely. A fresh alkaline battery can last up to 10 hours in use, but in
order to ensure optimum performance, it is recommended that you
replace the battery after every 7-8 hours of use.
2. Turn on the UH-10 by sliding the
OFF/STANDBY/ON SWITCH (16)
to
the STANDBY position (transmitter on, audio muted) or the ON position
(transmitter and audio both on). The
BATTERY INDICATOR LED (17)
will
give a single quick flash, indicating usable battery strength. In the case of
a dead or low battery, the LED will either not go on at all or will stay on
continuously, indicating that the battery should be replaced with a fresh
one. To preserve battery life, turn the transmitter off when not in use.
5
UH-10 HANDHELD MICROPHONE
13. BATTERY COMPARTMENT COVER
14. BATTERY HOLDER
15. 9V ALKALINE BATTERY
16. OFF/STANDBY/ON SWITCH
17. BATTERY INDICATOR LED
3. The microphone is now ready to use. The A and/or B
DIVERSITY LED
INDICATORS (2)
on the UHF 10 receiver should now be lit, indicating a
received signal from the transmitter. When ready to speak, slide the
transmitter switch to the ON position. Adjust the volume of the receiver as
per the Audio Output Microphone Connection section of the above UHF
10 receiver instructions.
[Note: Observe care in selecting P.A. volume,
transmitter location and speaker placement so that acoustic feedback
(howling or screeching) will be avoided.]
15
14
13
13
17
16
6
