RECEIVER OVERALL SYSTEM PERFORMANCE
Frequency Response: 20Hz – 20,000Hz +/-3dB
Dynamic Range: 120dB (A-weighted)
Total Harmonic Distortion:
<0.1%
Latency: 3mSec (48 kHz Sample Rate)
RF Carrier Frequency Range: Selected frequencies between 902 and 951MHz
Frequency Stability: +/- 20PPM, PLL controlled
Modulation: Digital QPSK
Operating Range: Up to 300 ft. typical (depending on site conditions);
optimum line-of- sight
DW-11/DW-22 RECEIVERS
Reception : External 7.25” (18.5cm) Antenna Attached
(DW-22 – dual antennas)
Receiver Sensitivity : -94dBm
Controls : Power ON/OFF, Volume Control
Connectors : 1/4” (6.35 mm) Unbalanced phone jack (360 mV/ no load)
XLR Balanced output (+/-12 mV/600 Ohm load)(2x for DW-22)
LED Indicators : Power ON, RF/AF LEDs
Unwanted Signal Rejection : 60dB image and spurious
Power Requirements : DC 13.5V Regulated @ 400mA
DC input : 2.1mm jack
Weight and Dimensions : DW-11: 0.75lbs (340g)
8” X 6” X 1.75” (203 X 152 X 44mm)
DW-22: 0.8lbs (363g)
8” X 6” X 1.75” (203 X 152 X 44mm)
DIGITAL HT™/DIGITAL LT™ TRANSMITTERS
RF Power Out : +13dBm, (50mW maximum allowed by FCC)
RF Spurious Emissions : < –50 dB
Audio Inputs : Digital HT™ Integral neodymium dynamic cartridge
Digital LT™ Bodypack : 1/8” (3.5mm) locking mini-jack, for headworn or
lavalier Mic
CONTROLS
HT/LT : Power On/Off, (LT) Audio Mute
LED Indicator : Unit on (single flash), Low Battery Alert (red)
Battery Type : 2 AA Alkaline
Battery Life : Up to 11 Hours
Weight and Dimensions : Digital HT™: 0.6lbs (272g) / 9.25”(L) X 2”(dia.)
Digital LT™: 0.15lbs (68g)/ 2.5” X 4.25” X 0.5”
(64 X 108 X 13mm)
OPTIONAL ACCESSORIES
RMT-1KUD rack tray for rackmounting either one or two DW-11/DW-22 receivers.
10
SPECIFICATIONS
