The CM 100 can be used in live or studio alignment applicatoins or studio recording. It must be powered by 48V phantom
power (such as supplied by the optional Nady SMPS-1 phantom power supply or a mixing console/alignment device equipped
with phantom power), and amplified by a microphone pre-amp (such as built into a mixer, or a stand-alone unit).
(Note: Make sure to set the pre-amp to the proper gain level—too much gain may distort subsequent amplifiers and too little
may result in a noisy signal)
The CM 100 can be connected to your mixer or phantom power supply using a standard balanced 3-pin XLR microphone
cable. Before connecting to a mixer directly, turn the channel to which you’re connecting to its lowest gain setting. If you are
using the Nady SMPS-1 Phantom Power Supply, connect in the following order:
1.
Connect the CM 100 to the SMPS-1
2.
Connect the SMPS-1 Signal Output to your mixer
3.
Connect the SMPS-1 to the AC power supply (115—230VAC)
4.
Turn on the SMPS-1 Power ON/OFF switch
Slowly turn up the channel gain in your mixer to the desired level
CONNECTING THE CM 100
SERVICE
CM 100 SPECIFICATIONS
Specifications and design subject to change for improvement purposes
(U.S.)
Should your Nady microphone require service, please contact the Nady Service Department via phone at
(510) 652-2411 or e-mail at [email protected].
(INTERNATIONAL)
For service, please contact the Nady distributor in
your country through the dealer from whom you purchased this product.
Do not attempt to service this unit yourself as it will void your warranty
Date of purchase ____________________________________________________________________________________________
Dealer’s Name ______________________________________________________________________________________________
Street ______________________________________________________________________________________________________
City ____________________________________State ____________________Zip______________________________________
11/04/03
Type
......................................Omni-directional electret condenser
Impedance
............................600 ohms
Sensitivity
..............................-40dB (0dB = 1V/Pa)
Frequency response
..............20Hz-20kHz
Current Consumption
............<2mA
Max. SPL
..............................>120dB SPL.
Connector
..............................Gold-plated XLR
Phantom power
....................15-48V
Size
......................................Diameter: .87" (22.22mm);
Length: 7.5" (190mm)
Weight
..................................4 oz (120 grams)
FREQUENCY RESPONSE
