(U.S.)
Should your NADY AUDIO product require service, please contact the Nady Service Department by telephone at (510) 652-2411
or e-mail at [email protected].
(International)
For service, please contact the NADY AUDIO distributor in your country through the dealer from whom you purchased
this product.
S E R V I C E
FOR YOUR NADY AUDIO PRODUCT
NADY SYSTEMS, INC.
• 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608
Tel: 510.652.2411 • Fax: 510.652.5075 • www.nady.com
R E A R
C O N T R O L S
Pantone 185 Red/Black
Black
(1) POWER ON/OFF SWITCH
(2) AC POWER CORD IEC CONNECTOR w/ internal fuse holder
Connects to the AC power cable.
Fuse: 115VAC ~ 3A 250V 20mm glass tube
230VAC ~ 2A 250V 20mm glass tube
(3) AC SELECTOR SWITCH
Before plugging in the power cord, check to see that this switch is set to the proper
voltage for your area: ~115V (60Hz) or ~230V (50Hz).
Note: Units damaged due to powering up with the wrong voltage are not covered
under warranty.
(4) POWER ON LED
(5) CLIPPING LED
This LED turns red when the output signal is clipping. It is acceptable if the red LED
lights occasionally. If the red LED lights more than occasionally, you should turn
down the volume to avoid audible distortion and damage to the speaker.
Note: Speakers damaged due to hard clipping are not covered under warranty.
(6) MIC INPUTS
Balanced XLR and 1/4" TRS inputs for use with a mic level input signal.
(7) MIC LEVEL CONTROL
(8) LINE INPUTS
Balanced XLR and dual RCA inputs for use with line level input signals.
(9) LINE LEVEL CONTROL
(10) LINE OUTPUTS
Balanced XLR and 1/4" TRS outputs. Master Volume/Bass/Treble controls do not
affect these outputs.
(11) MASTER VOLUME CONTROL
This controls the volume sent to the speaker. Adjust as needed.
(12) TREBLE EQ
Adjusts treble frequ/-12dB.
(13) BASS EQ
Adjusts bass frequ/-12dB.
(6)
(2)
(4)
(5)
(7)
(9)
(10)
(12)
(11)
(1)
(13)
Power:
360W Peak (180W RMS)
Frequency Response:
70 Hz - 20 KHz (+/-3 dB)
Treble EQ:
±12 dB @ 10 KHz
Bass EQ:
±12 dB @ 100 Hz
LF Driver:
10” woofer, 4 Ohms (2” voice coil)
HF Driver:
5.5” x 8” horn, compression tweeter, 4 Ohms (1” voice coil)
Max SPL:
101dB @1M
Total THD:
<2%
Weight:
27.6 lbs (12.6 Kg)
Dimensions (HWD):
19.4” x 14” x 11.4” (49.3 x 35.6 x 29cm)
(3)
(8)
S P E C I F I C A T I O N S
