background image

1.   POWER SWITCH:

To turn the unit ON or OFF, press the upper or lower 
portion of this button. The internal power LED illuminates 
when the unit is turned “ON”. (Caution: Always turn the 
Crossover ON before the amplifier, and turn it OFF after 
the amplifier or transients harmful to the speakers may result.)

2.    L/M/H OUTPUT LEVEL CONTROLS:

These are used to adjust the output level of each way:  LOW, MID
and  HIGH .

3.    LOW CUT BUTTONS FOR LOW WAY:

These insert low cut filters in the LOW way of each stereo channel
with a 12dB/Octave, 30 Hz HPF to minimize problems from subsonic
frequencies in the signal, to suppress hum, and to prevent low fre-
quency speaker resonance.

4.   MH CROSSOVER FREQUENCY CONTROLS:  

These select the crossover frequencies of the MID and HIGH ways. They’re a low cut for the HIGH and a high
cut for the MID. You can select the frequencies between 480 Hz to 7 kHz.

5.    LM CROSSOVER FREQUENCY CONTROLS: 

These select the crossover frequencies of the LOW and MID ways. They’re a low cut for the MID and a high
cut for the LOW. You can select the frequency between 70 Hz to 1 kHz.

6.   PHASE BUTTONS:

These allow switching the polarity to invert the signal phase on the MID and HIGH ways. This is done after the
output levels are set to correct audible phase problems.
Caution: Before pressing the PHASE BUTTON, always lower the outputs of your power amplifiers to avoid pos-
sible speaker damage.

7.   SUB CROSSOVER FREQUENCY CONTROL:

This selects the crossover frequency of the SUB WOOFER way. You can select the frequency between 50 Hz to
250 Hz.

8.   SUBWOOFER OUTPUT LEVEL CONTROL:

This is used to adjust the SUB WOOFER output level.

9.   SUBWOOFER LOW CUT BUTTON:

This inserts a low cut filter in the SUBWOOFER way with a 12dB/Octave, 30 Hz HPF to minimize problems
from subsonic frequencies in the signal, to suppress hum, and to prevent low frequency subwoofer speaker
resonance.

CONTROLS AND CONNECTIONS

FRONT PANEL

8

5

4

3

2

6

1

9

4

PLEASE READ THIS MANUAL

BEFORE OPERATING THIS UNIT 

Caution : To prevent malfunctioning

and/or possible equipment damage: 

Before plugging the unit into the power

source: (1) the voltage selector switch

should be set  for the correct voltage for

your area (115V or 230V) and (2) all

equipment connected to the crossover

outputs should be turned off or all the

inputs turned down.

7

2

5

4

3

6

Reviews: