NAD T975 Datasheet Download Page 2

T975’s integral 12V trigger turn-on response. This multi-channel 

amplifier delivers its output via heavy-duty “five-way” connectors. 

Ruggedness  and  in-system  reliability  are  critical  to  successful 

home theatre systems. The T975 uses a unique variable speed 

fan cooling system first introduced on the M25 Masters Series 

amplifier, allowing the T975 to deliver massive amounts of power 

for hours on end. Many lesser amps thermally protect and cycle 

on and off when asked to perform at their maximum causing an 

unpleasant disruption of the movie. While a well designed forced 

air system can eliminate thermal cycling, it is crucial to keep the 

noise  of  the  cooling  fan  from  intruding  -  especially  during  quiet 

passages of the movie or music. To this end, we have developed a 

unique circuit that measures not only the operating temperature 

but  also  the  level  of  the  input  signal,  automatically  silencing  the 

fans during quiet passages.

This  amplifier  utilizes  a  combination  of  fuse  and  electronic  non-

intrusive  protection:  dependable,  fail-safe,  and  sonically  benign. 

Each channel is fully protected against excess temperature, DC 

fault, and loudspeaker short-circuit. 

PowerDrive™

The  T975  also  benefits  from  NAD’s  proprietary  PowerDrive™ 

circuit  topology,  now  well  established  and  used  throughout 

the  NAD  product  range.  The  PowerDrive  topology  allows  the 

T975  to  deliver  maximum  performance  under  virtually  any 

circumstance, independent of the loudspeakers it is driving. The 

circuitry  automatically  senses  the  impedance  characteristics  of 

the  loudspeaker  and  will  then  adjust  its  power  supply  settings 

to  best  cope  with  that  specific  load.  PowerDrive  topology  is  a 

practical  approach  to  enable  an  amplifier  to  easily  deal  with 

musical  dynamics  and  difficult  speaker  loads.  Thus  we  have  the 

highly  desirable  characteristics  of  high  dynamic  power  and  low 

impedance drive capability in one affordable package. 

NAD also takes a stand against the meaningless “brochure power” 

touted  by  many  of  our  competitors  by  offering  Full  Disclosure 

Power specs. We specify minimum continuous power, across the 

entire audible range of frequencies, at rated distortion, for both 

8 and 4 Ohms with all channels driven simultaneously. Perhaps 

even more importantly, we also specify Dynamic Power at 8, 4, 

and even 2 Ohms, which better describes the way the amplifier 

will  perform  in the  real  world,  with  musical  signals and reactive 

loudspeaker loads. 

But even the most carefully reported specs cannot fully describe 

the  sonic  performance  of  an  amplifier.  Only  your  own  ears  can 

finally judge our achievement. We urge you to listen and compare 

NAD  to  other  products  in  its  price  range,  and  even  higher.  We 

don’t  think  you’ll  find  anything  that  comes  close  to  offering  the 

T975’s  overall  musical  satisfaction,  well-rounded  performance, 

and stellar value for money. 

SPECIFICATIONS

Simultaneous Full Disclosure Power
(4/8 Ohms, 20Hz - 20kHz, at rated distortion) 

Minimum Continuous Power (FTC)

Rated Distortion (THD 20Hz-20kHz)

Clipping Power (0.1% THD)

IHF dynamic power at 8 Ohms

IHF dynamic power at 4 Ohms 

IHF dynamic power at 2 Ohms

Damping Factor

Input Impedance

Input Sensitivity

7 x 140W (21.5dBW)

7 x 250W (24dBW)

0.03%

170W (22.1dBW)

230W (24dBW)

390W (26dBW) 

450W (26.5dBW)

ref. 8 Ohms, 50Hz >300

50K

1.1V

Voltage Gain

Frequency Response

Signal/Noise Ratio 

ref. 1W 

 

 

ref. rated power 

Net Dimensions (W x H x D)

Gross Dimensions (W x H x D)*

Net Weight

Shipping Weight

29.0dB

20Hz - 20kHz +0, -0.2dB

2Hz - 100kHz -3dB

95 dB

125dB

17 1/8 x 7 1/8 x 17 3/4”

(435 x 181 x 451mm)

17 1/8 x 7 5/8 x 18 3/4”

(435 x 194 x 476mm)

68 lbs (31kg)

72 lbs (33kg)

* Gross dimensions include volume knob / speaker terminals / connectors / feet.
Note: Installers should allow a minimum clearance of 2 - 4 inches for  
wire management.

NAD Electronics International reserves the right to change specifications or features without notice. NAD is a registered trademark of NAD Electronics

International. All rights reserved. No part of this publication may be reproduced, stored, or transmitted in any form whatsoever without the written

permission of NAD Electronics International. © 08/07 NAD Electronics International.

www.NADelectronics.com

Reviews: