TROUBLESHOOTING
Always turn down the volume to a low level or turn off all equipment before checking.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
No sound.
• (LED is not illuminated) Power Supply not connected
to either NAD PP 2e or mains socket.
• Plug in dedicated Power Supply.
• (LED is illuminated) Wrong input on amplifier/receiver
selected.
• Select input to which NAD PP 2e is connected.
• Check to see if the MM/MC selector switch is set
correctly for your type of turntable cartridge (make
sure to turn off all equipment beforehand).
• Plugs from turntable and/or lead from NAD PP 2e to
amplifier/receiver sockets not property fitted.
• Check all connections (make sure to turn off all
equipment beforehand).
Sound in one channel only.
• Plugs from turntable and/or lead from NAD PP 2e to
amplifier/receiver sockets not property fitted.
• Check all connections (make sure to turn off all
equipment beforehand).
Hum or Buzz noise.
• No connection from turntable to ground.
• Connect the turntable’s earth (GND) lead directly to
a ground connection or to NAD PP 2e’s thumb screw
terminal “GND” which provides the grounding.
• Earth loop present.
• If connected, disconnect turntable’s earth lead from
amplifier/receiver.
• Interference from nearby equipment
• Move NAD PP 3i and cables further away from other
equipment.
SPECIFICATIONS
MM SPECIFICATIONS
Input impedance (R and C)
47 kohms + 200 pF
Gain at 1 kHz
34 dB
Input sensitivity (ref. 200 mV output)
2.5 mV
Signal-to-noise ratio
80 dB
(A-weighted, with cartridge connected)
67 dB
(Unweighted, with cartridge connected)
Input overload (20Hz/1kHz/20kHz)
10/102/950 mV
Total Harmonic Distortion
<0.03%
RIAA response accuracy
±0.3 dB
MC SPECIFICATIONS
Input impedance (R and C)
100 ohms + 180 pF
Gain at 1 kHz
58 dB
Input sensitivity (ref. 200 mV output)
0.3 mV
Signal-to-noise ratio
78 dB
(A-weighted, with cartridge connected)
67 dB
(Unweighted, with cartridge connected)
Input overload (20Hz/1kHz/20kHz)
0.8/9/84mV
Total Harmonic Distortion
<0.03% (20 Hz – 20 kHz at 3V output)
RIAA response accuracy
±0.3 dB
GENERAL SPECIFICATIONS
AC supply
External 23.5V DC
Unit dimensions (W x H x D)
135 x 43 x 72 mm
5.3 x 1.7 x 2.8 inches
Specifications are subject to change without notice.
For updated documentation and features, please check out
www.NADelectronics.com
for the latest information about PP 2e.
©2015 NAD ELECTRONICS INTERNATIONAL, A DIVISION OF LENBROOK INDUSTRIES LIMITED
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited.
No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.
While every effort has been made to ensure the contents are accurate at the time of publication, features and specifications may be subject to change without prior notice.
PP2E_ENG_OM_V03 - 04/15