NAD Electronics International reserves the right to change specifications or features without notice. NAD is a registered trademark of NAD Electronics
International. All rights reserved. No part of this publication may be reproduced, stored, or transmitted in any form whatsoever without the written
permission of NAD Electronics International. © 05/09 NAD Electronics International.
www.NADelectronics.com
> S P E C I F I C A T I O N S
Pre-Amplfier Section
Line level input, Pre OUT
THD (2V in 2V out,
CCIF IMD, DIM 100)
>0.004% (ref. 20Hz – 20kHz)
Signal/Noise ratio IHF
>102dB (A-weighted, ref. 500mV)
>110dB (A-weighted, ref. 2V,
Volume maximum)
>92dB (A-weighted, ref. 100mV in
100mV out - unity gain)
Channel separation 1kHz
>80dB
10kHz
>70dB
Input impedance (R and C)
100kΩ+ 320pF
Maximum input signal
>8V rms (ref. 0.1 THD)
Output impedance
Pre out
75Ω
Variable out
<325Ω
Tape out
Source Z + 1kHz
Input sensitivity
158mV (ref. 500mV out)
Frequency response
± 0.1dB (ref. 20Hz - 20kHz, Tone defeat ON)
± 0.5dB (ref. 20Hz - 20kHz, Tone defeat OFF)
Maximum voltage output
IHF load
>10V (ref. 0.03% THD)
600 ohm load
>10V (ref. 0.03% THD)
Tone Controls
Treble
± 5dB at 10kHz
Bass
± 8dB at 100Hz
Power Amplfier Section
Main IN, Speaker OUT
Continuous output power
into 8Ω and 4Ω (Stereo)
>150W (ref. rated THD,
20Hz-20kHz, both channels driven)
Continuous output power
into 8Ω (Mono, Bridge mode)
>330W
Rated THD
(CCIF IMD, DIM 100)
<0.009% (ref. 20Hz - 20kHz)
Clipping power
>170W (ref. 1kHz 1% THD)
IHF dynamic power
8Ω
250W
4Ω
410W
2Ω
600W
IHF dynamic power
8Ω
800W
(Bridge mode)
4Ω
1200W
Peak output current
>50A (ref. 1Ω, 1ms)
Signal/noise ratio
>102dB (A-weighted, ref. 1W)
>123dB (A-weighted, ref. 150W)
Power Amplfier Section - continued
Damping factor
>200 (ref. 8Ω, 50Hz and 1kHz)
Frequency response
± 0.1dB (ref. 20Hz - 20kHz)
3Hz – 70kHz (ref. -3dB)
Input impedance
10kΩ + 200pF
Input sensitivity
1.2V (ref. rated power)
Voltage gain
29dB
Headphone output impedance
68Ω
Channel separation
1kHz
>85dB
10kHz
>75dB
Trigger Out
Output resistance
<120Ω
Output current
50mA
Output voltage
+12V
Overall Specifications
CD IN, Speaker OUT
THD (250mW to rated power,
CCIF IMD, DIM 100)
<0.009% (ref. 20Hz - 20kHz)
Signal/Noise ratio
>94dB (A-weighted, ref. 1W)
>113dB (A-weighted, ref. 150W,
volume set for 2V input)
Frequency response
± 0.2dB (ref. 20Hz - 20kHz, Tone Defeat ON)
10Hz – 65kHz (ref. -3dB)
Channel separation
1kHz
>80dB
10kHz
>70dB
Power Consumption
Rated power
290W (ref. 230V AC 50Hz; 120V AC 60Hz)
Standby power
<1W
Idle power
<120W
Dimension and Weight
Dimensions (W x H x D)
Net
435 x 133 x 352mm
Gross*
435 x 150 x 396mm
Net weight 15.3 kg
Shipping
weight
18.0 kg
* Gross dimensions include feet, extended buttons and rear panel terminals.
Note: Installers should allow a minimum clearance of 55mm for
wire/cable management.
C 375BEE Integrated Amplifier