ENGLISH
13
IDENTIFICATION OF CONTROLS
SR 10 REMOTE CONTROL
AUX PLAYER CONTROL (applicable to NAD Tuners):
Select
AUX
among the DEVICE
SELECTOR buttons to gain access to the following applicable control buttons. The AUX device
is defaulted to NAD Tuner device remote control codes.
SOURCE [
D/F
]:
Step up or down between AM or FM frequencies
D/F
:
Step up or down between stored radio presets
A/S
:
Step up or down between AM or FM frequencies
ENTER:
In AM/FM mode, toggle to select Preset or Tune mode. In DAB mode, press and hold
to check signal strength.
NUMERIC KEYS (1-9, 0):
Use the numeric keys to directly key-in frequency number of desired
AM or FM station
INFO:
Toggle to display supplied information about the current radio station and applicable
media being played. Some radio stations may not support any display information.
u
:
Toggle to select AM, FM, DAB or XM band (if applicable)
9/ :
:
Step up or down between stored radio presets
USING THE SR 10 REMOTE CONTROL LIBRARY
The SR 10 can store a different library of default NAD codes for each of its DEVICE SELECTOR
“pages.” If the original default library does not control your NAD CD player, BluOS player or
Tuner, follow the procedure below to change the library code. Refer also to the table below for
a list of applicable NAD Library Codes with their corresponding NAD models.
LOAD ANOTHER LIBRARY CODE
Example:
Load NAD DVD Player T 517 library codes to SR 10’s “AUX”device.
1
Press and hold [AUX] in the DEVICE SELECTOR section of SR 10.
2
While holding down the device button AUX, press “2” and “2” using SR 10’s numeric
buttons. “22” is the corresponding library code for T 517.
3
Press [ENTER] while still holding down the device button (AUX). The AUX device selector
will flash once to indicate that the library input is successful. Both the device selector
button (AUX) and [ENTER] can now be released.
TABLE OF LIBRARY CODES APPLICABLE TO SR 10 REMOTE CONTROL
LIBRARY CODE
PRODUCT DESCRIPTION
10
Default library for “AMP” page
11
Zone 2
12
Default library for “AMP” page without discrete ON/OFF (toggle ON/OFF) buttons
20
Default library for “CD” page; C 515BEE, C 545BEE, C 565BEE
21
T 535, T 585, M55, DVD section of L 54, VISO TWO, VISO FIVE
22
T 513, T 514, T 515, T 517
23
T587
30
Default library for “BLS” page
31
IPD 2
40
Default library for “AUX” page. Loaded with Tuner default codes. Applicable also to Tuner section of C 725BEE, T 175,
T 737,T 747, T 755, T 765, T 775, T 785
41
C 422, C 425
42
C 445
50
DAC
IMPORTANT
The SR 10 may not necessarily contain all the control buttons applicable for the above-
mentioned NAD products. Use the prescribed remote control of the specific NAD product for
a full complement of applicable remote control buttons.
RESET SR 10 TO ITS FACTORY DEFAULT SETTINGS
The SR 10 remote control can be restored to its factory default settings (including default
libraries) by the following procedures.
1
Press and hold [ON] and [RETURN] buttons.
2
As soon as [AMP] device button lights up, release hold of both [ON] and [RETURN] buttons.
3
If the [CD] device button flashes twice, the SR 10 factory reset is completed.
