EXAMPLES OF INCORRECT AZIMUTH SETUP
Too much left angle
Too much right angle
The correct position is 100% perpendicular to the record.
7 ANTI-SKATING ASSEMBLY AND ADJUSTMENT
The anti-skating mechanism is shipped partially disassembled to avoid
damage during transport. For correct installation, please follow the
steps below.
Step 1
Prepare all parts supplied from the accessories bag:
•
Anti-skating sliding mechanism with anti-skating weight and thread
for mounting on the tonearm
Step 2
Put the anti-skating sliding mechanism on the end of the anti-skating
support rod.
NOTE
Be careful when handing the anti-skating thread in order to avoid
damaging it.
Step 3
The anti-skating sliding mechanism is supplied with a pre-mounted
anti-skating weight and anti-skating thread. Put the eye of the anti-
skating thread around the hole for the HOOK SCREW and screw the
HOOK SCREW into the tonearm through the eye of the anti-skating
thread as shown in the illustration below.
Step 4
Anti-skating force adjustment:
Adjust the anti-skating force by positioning the weight on the
appropriate groove of the anti-skating sliding mechanism. Anti-skating
downforce should be adjusted in correspondence with the tonearm
downforce as follows:
Tonearm downforce
Anti-skating groove
Lower than 13 mN or 1.3 grams
1st groove from bearing
13–18 mN or 1.3–1.8 grams
2nd groove from bearing
18–25 mN or 1.8–2.5 grams
3rd groove from bearing
SETUP
ASSEMBLY AND INSTALLATION
7
ENGLISH
POR
TUGUÊS
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
