15
The rear wall of the refrigerator, in particular, the condenser and other elements of the
cooling system must not contact other elements, which may damage them, (e.g. central
heating pipes and the water supply pipes).
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above- mentioned distances, provide an
appropriate insulation board.
•
Do not cover the ventilation holes at the top of the
appliances– it must be a good air circulation
around the appliance. There should be a gap of
at least 10 cm between the top of the appliance
body and any furniture that may be above it. If
this requirement is not followed, the appliance
consumes more electrical energy and its
compressor may overheat.
•
The appliance must stand on a level surface and must not touch the
wall. If necessary, regulate the height of the appliance by adjusting
the levelling feet: by turning them clockwise – the front of the
appliance rises, by turning them counter clockwise – it comes down. If
the appliance is tilted slightly backward – the doors will close by
themselves.
•
If the appliance is placed in a corner, a gap of at least 60 mm must
be left between the appliance body and the wall (see fig
.
)
Preparing for operation:
•
It is recommended to prepare the appliance for operation with a helper.
•
Remove package. Remove the separate polystyrene part (transport protection) between the rear of
the device and condenser – metal grid (if available).
•
Lift the appliance away from foamed polystyrene base. When placing, moving, lifting the appliance,
do not hold the door handles, do not pull the condenser at the rear part of the refrigerator and do
not touch the compressor unit.
•
When positioning the appliance in chosen location, it will move more easily into position if you lift
the front a little and incline it backward, allowing it to roll on its casters.
•
Remove all red-coloured parts from the shelves. Tear away the adhesive tapes – they are intended
only for the transport of the appliance.
•
The appliance
should not be connected
to the mains until all packing and
transport materials aren’t removed.
Take two supports
1
from the bag (see fig.) and insert them into the
guides
2
at the top back part of the appliance.
First use:
•
When the unit is fi rst switched on, a slight ‘new’ smell may be noticed. However, this will disappear
once the cooling process has begun.
Wait at least 4 hours before connecting the appliance to the power
supply
. This is to allow the oil to flow back in the compressor.
If this is not
done, the appliance compressor may fail.
•
When first starting-up or after a period out of use, before putting the products in the compartment
let the appliance run at least 2 hours
.
Summary of Contents for FK 2610
Page 2: ...1 ...
