2. Drill the holes to a depth suitable for your fixings in the marked positions using a masonry drill.
If the product is to be fitted onto a ceramic tiled wall, a ceramic drill bit should be used.
3. Insert the wall plugs flush to the surface of the wall. If fitting to a tiled surface, the wall plugs
should be inserted below the surface of the tile to avoid cracking.
4. Insert the wall screws through the holes of the wall brackets and screw securely to the wall. (FIG.2)
5. Clip the large bracket covers over the protruding grab bar pillar and clip onto the wall bracket. (FIG.3)
6. Slide the small bracket cover into position by aligning the corresponding bosses and channels.
Clip the small bracket cover onto the large bracket cover to complete the installation. (FIG.3)
7. Please check the grab bar is securely fitted to the wall before its first use.
Additional Information
This product must only be fitted to solid brick, concrete block wall or similarly strong materials
offering appropriate support for the maximum safe working load.
Maximum safe working load for the Grab N Grip range is 100kg when fitted to a
suitable surface.
Product Care Advice
To retain the best quality finish, clean product regularly with a soft damp cloth.
Do not use abrasive or chemical cleaners, as these will damage the product.
Wolseley UK Ltd, Warwickshire CV31 3HH. UK
Tel. +44 (0) 87 0067 7090
www.wolseley.co.uk
www.nabis.co.uk
S&H 029 R02
1
2
3
3 SCREW FIXINGS TO BE USED
PER BRACKET.
SCREWS & WALL PLUGS
NOT SUPPLIED.