: 230-240V~ 50/60 Hz
: 110°
: 2.2 m.
: 11 m
: 380lm
: 5 sec.
±
4 sec. / 5,5 min.
±
12 sec.
: IP65 Class II
: -20 °C ~ +40°C
: 11,7W
SPECIFICATIONAS
10211
Operating voltage
Angle of coverage
Detection hight
Detection range
Lumen
Time adjustment
Protection class
Oprt. temperature
Power consumption
L
N
TROUBLESHOOTING
MALFUNCTION
CAUSE
SOLUTION
• Light is off
• There is no
electricity on the
device
• Continuously
light is on
• Change perception
area in device
• Daylight adjustment set to
night-time mode during daytime
operate
• Power switch off or no electricity
• Fuse faulty
• Fuse switch off or fuse faulty
• Connection faulty.
• Continuously movement in detection
zone
• Cars on the streets are being
detected.
• Wind, rain, snow is moving to the
trees & bushes or open windows in
detection zone.
• Sudden temperature changes due
to weather (wind, rain, snow) or the
air expelled from fans.
• Different ambient temperatures.
• Control daylight setting and
re-adjust
• Check the electricity and power on.
• Change the fuse.
• Check the fuse if necessary use
a new fuse.
• Check the connection cables.
• Check the detection zone.
• Avert it is being detection.
• Change detection zone, change
site of installation.
• Change site of installation or
keep the reasons away.
• Change site of installation.
SETTING
(d) (LUX) Daylight setting
The sensor’s response threshold can be infinitely varied from 2-2000 lux.
If you turn the knob anti-clockwise device will operate at dark.
Control dial set clockwise = daylight operation approx. 2000 lux.
Control dial set anti clockwise = night-time operation approx. 2 lux.
(e) (TIME) Time setting
Light ON time can be adjusted continuously from
“5 sec.
±
4 sec. / 5,5 min.
±
12 sec.” If you turn the knob anti-clockwise device
will operate at minimum time.
Control dial set to anticlockwise = Shortest time (5 sec.
±
4 sec.)
Control dial set to clockwise= Longest time (5,5 min.
±
12 sec.)
NOTE:
Device will automatically make its own offset by checking environment for
approximately 5 minutes after the first installation. After this period device will operate
normally. If you think the device does not operate normal in first installation, please
wait for 5 minutes and start to test again. Be sure that there is no motion by this period.
10211
WATERPROOF WALL-LIGHT WITH LED
110° MOTION SENSOR
Detection range is determined at the temperature of +20°C
(L) = Line conductor
(N) = Neutral conductor
Connect line (L) and neutral (N) to the terminal block.
DETECTING RANGE
SYSTEM COMPONENTS
Walking directly to the sensor
(lower detection range)
Walking targential to the sensor
(normal detection range)
Figure-1
(a) Body
(b) Plastic Glass
(c) Protection cover
(d) Screw Hole of Glass Holder
(e) Mounting Holes
(f) Terminal
USAGE AREAS
• At the building entrances, stair vestibules.
• At the long halls within the flats.
• At the places required within the flats.
• At the parking garage.
• At the requisite locations within the hotels.
• At the schools, hospitals and oil filing station.
“OFFERS ENERGY SAVING FEATURE’’
GENERAL SECURITY CAUTIONS
• Take off the original package and control if there is any damage of transportation and general
view of the product.
• Do not use the product at cross purposes.
• Do not supply high voltage.
• Protect from any stroke.
• Using 230-240V~ voltage is so dangerous that only the specialist electricians must install
and apply.
CAUTIONS FOR INSTALLATION AND USAGE
• Installing must be carried out professionally in accordance with applicable national wiring and
electrical operating conditions.
• Turn off the network before mounting.
• Use 6A fuse the supply input.
• Factory setting; daylight adjustment is at darkness, time adjustment is at the shortest.
• Setting can be made 10 - 15 second after the releasing of the power.
• Time and daylight setting can be made during the day or night.
• Do not change the time and daylight settings abruptly.
• Do not make a second adjustment before you get a result from the first setting of the time
and daylight.
• After you determine the right setting of the daylight, you can arrange the time as you need.
• The best result for the daylight setting can be obtained by adjusting the minimum. And that
you can find the correct setting for sensitivity incrementally.
• Avoid mounting the detector close to objects that can cause rapid temperature changes such
as heaters, fans, refrigerators and ovents etc, and prevent the detector from point-blank
sunshine.
• It can cause the device operate inaccurately if there is tree, brushes etc. in the coverage area.
Using supplied mounting screws, assembly the body of product figured as (a) through mounting
holes figured as (e) as a parallel to surface. Wire the connection of L-N to terminal figured as
(f). Set the control dials according to the environment conditions than assembly the glass figured
as (b) to body of product using glass holder screws carefully. Finally fix the protection cover
figured as (c).
DETECTION AREA :
Detection area of motion sensors depends on the angle between PIR detector and moving
direction, temperature mounting style and mounting place. Environment temperature will also
cause decrease of detection range. Detection range is determined at +20°C. If the weather is
hot, it will decrease.
The maximum detection range can be realized when walking tangential to the sensor (figure1)
When walking directly to the sensor detection range will be low. Because you will not be able
to cut vertical areas. Detection range of 10211 model is 11 m.
GUARANTY
We will remedy defects caused by material flaws or manufacturing faults. The warranty will be
met by repair or replacement at our own discretion. Further consequential damage to other
object is excluded. Claims under the warranty will only be accepted if the unit is sent fully
assembled and well packed complete with a brief description of the fault, a receipt or invoice
(date of purchase and dealer’s stamp) to the appropriate Service Center
KK-10211_160401_EN_00
Sensor
Top View
Wall
11 m.
11 m.
Complies with ROHS Regulation Directive
2002/95/EC
www.na-de.com.tr • [email protected]
‹stanbul Deri Organize Sanayi Bölgesi Tufle Sok. No:8 M1-8 Özel Parsel 34953
Tuzla / ‹STANBUL - TÜRK‹YE
11 m.
2.2 m.
110°
+
-
(e)
+
-
(d)
(c)
(b)
(a)
(e)
(e)
(d)
(d)
(f)
