(Revised 2013-23-10)
Page 17 of 62
TROUBLESHOOTING
1.
Make sure the PWR (Power LED) is ON.
2.
Make sure you are supplying sufficient current for the version chosen. Note: The Inrush
current will exceed the steady state current by ~ 2X.
3.
Verify that Link LED is ON for the connected port.
4.
Verify cabling used between stations.
5.
Verify that cabling is Category 5E or greater for 100Mbit operation.
SUPPORT
Contact N-Tron Corporation at:
TEL: 251-342-2164
FAX: 251-342-6353
E-MAIL:
WEB:
www.n-tron.com
FCC STATEMENT
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
ANTENNA STATEMENT
The regulatory domain this equipment is installed in has a legal limit for the equivalent isotropic radiated
power (EIRP) that is determined by the output power and the antenna gain. It is the installer’s responsibility
to make sure this rule is not violated. All equipment should be professionally installed. After proper
installation the device should be properly protected to ensure regulatory compliance.
FCC sets the maximum gain for the following antenna types for the 702-W Radios;
2.4GHz Omni-Directional 5dBi
2.4GHz Panel Directional 17dBi
5.8GHz Panel Directional 21dBi
5.8GHz Parabolic Dish 32dBi
NOTE: External Antennas should be installed and operated with a minimum distance between the radiator
and any person or operator. This distance is determined by the regulatory domain the equipment is installed
in and should be calculated by the installer at the time of installation to ensure regulatory compliance and the
safety of operators around the radiator.
