N-Tron 7018, User Manual & Installation Manual

Page: 119 / 138

(Revised 8/3/2009)
Page 119 of 138
CLI Commands, Continued…
Show or Set Port Configuration
Command Name Port
Description Show or set Port configuration.
Syntax port [-show] [-admin state] [-sd auto | 10h | 10f | 100h | 100f | 1000h | 1000f]
[-flow state] [-fhp state] [-dp prio] [-pvid vid] portno
Parameters
portno
Port number to configure or show. Specify “all” to show all ports.
-show
Show configuration.
-admin state
Set the admin status for the port to e(nabled) or d(isabled).
-sd
Set the speed and duplex mode for the port.
auto = enable auto-negotiation
-flow state
Set the flow control for the port to e(nabled) or d(isabled).
-fhp state
Set force high priority for the port to e(nabled) or d(isabled).
-dp
Set the default QOS priority for the port. The range is 0-7.
-pvid
Set the VLAN ID for the port. The range is 1-4094.
Examples N-TRON/Admin> port –sd 100f –flow enabled –dp 7 –pvid 2 5
Port Port Admin Link Auto Port Dupl Flow Force Def Port
No Name Status Stat Nego Spd Mode Control High Pri Pri State PVID
---- ---- -------- ---- -------- ---- ---- -------- -------- --- ---------- ----
5 TX5 Enabled Down Disabled 100 Full Enabled Disabled 7 Disabled 2
Changes have been made that have not been saved.
…
NOTES
Reset the Switch
Command Name Reset
Description Reset (reboot) the switch
Syntax Reset
Parameters None
Example
N-TRON/Admin> reset
Performing Soft-Reset...
…
Notes