N-Tron 7012FX2 Series, User Manual & Installation Manual

Page: 168 / 170

(Revised 2012-05-01)
Page 168 of 170
</ IPConfiguration >
<! -- ______________________________________________________________________________________ -- >
<! -- User management -- >
<! -- A list of logon accounts (5 maximum) to add to the switch. -- >
< Users mode ="keep or delete"> <! -- mode must be "keep" or "delete" -- >
<! -- mode=delete - delete existing accounts before adding accounts (default) -- >
<! -- mode=keep - do not delete existing accounts before adding accounts -- >
<! -- All User elements (name, password, access) are required. -- >
< User >
< Name > Joe </ Name > <! -- 3-15 character limit -- >
< Password > xxx </ Password > <! -- 3-15 character limit -- >
< Access > admin OR user </ Access > <! -- Access must be admin or user -- >
</ User >
</ Users >
<! -- ______________________________________________________________________________________ -- >
<! -- Port configuration -- >
<! -- You may uses this block to define port VLAN identifiers (PVIDs) -- >
< Ports >
< ValidatePorts > yes OR no </ ValidatePorts > <! -- optional -- > <! -- Must be yes(default)
or no. If no, invalid ports are ignored. -- >
<! -- Use PortNumber or PortName -- >
< Port >
< PortNumber > 4 </ PortNumber > <! -- PortNumber ranges from 1 to the maximum port
number for the switch -- >
< PVID > 1 </ PVID > <! -- PVID ranges from 1 to 4094 -- >
</ Port >
< Port >
< PortName > TX6 </ PortName > <! -- Name of port on switch -- >
< PVID > 26 </ PVID > <! -- PVID ranges from 1 to 4094 -- >
</ Port >
</ Ports >
<! -- ______________________________________________________________________________________ -- >
<! -- DHCP server -- >
< DHCPServer mode ="keep or delete"> <! -- mode must be "keep" or "delete" -- >
<! -- mode=delete - delete existing profiles before adding profiles (default) -- >
<! -- mode=keep - do not delete existing profiles before adding profiles -- >
< Enabled > yes OR no </ Enabled > <! -- Enabled must be yes or no -- >
<! -- If the server is enabled (enabled=yes), you can add DHCP server profiles.
(If not enabled, can not add profiles.) -- >
< Profile >
<! -- Required: Name, LowIP, HighIP, LeaseDays. LeaseHours is optional, and
defaults to 0. -- >
< Name > prof1 </ Name > <! -- required -- > <! -- 19 character limit -- >
< LowIP > 192.168.2.1 </ LowIP > <! -- required -- >
< HighIP > 192.168.2.254 </ HighIP > <! -- required -- >
< LeaseDays > 28 </ LeaseDays > <! -- required -- >
< LeaseHours > 0 </ LeaseHours > <! -- optional -- >
<! --The Advanced block is optional, and all elements within the block are
optional.-- >
< Advanced > <! -- optional -- >
<! -- All elements below are optional -- >
< BroadcastAddress > 192.168.2.255 </ BroadcastAddress >
< DomainName > N-TRON.com </ DomainName > <! -- 63 character limit -- >
< DNSServer1 > 192.168.2.10 </ DNSServer1 >