4
The warranty period does not run from the date when the buyer reports the defect covered by
the warranty and due to which the buyer cannot use the goods to the seller, thus exercising
his/her rights arising from the liability for defects covered by the warranty, until the date of its
removal by the seller.
The warranty does not apply to natural and common wear and tear of the goods and defects
caused due to improper use of the goods contrary to the provided training and documentation.
Furthermore, the guarantee does not apply to defects caused due to overloading of the goods
or to defects caused after unprofessional intervention in the goods or unprofessional repair or
modification to the product. The unprofessional intervention, repair or maintenance shall
mean any intervention, repair or maintenance carried out contrary to the provided training of
documentations or carried out by a person other than the seller or a person authorized and
approved by the seller.
The rights arising from the liability for defects covered by the warranty shall be exercised at
the seller without undue delay after the seller finds out the defect, but no later than the end of
the warranty period; otherwise these rights void.
The warranty card must be submitted upon exercising of rights arising from the liability for
defects covered by the warranty; otherwise these rights cannot be conferred upon the buyer.
Seller’s liability for defects covered by the warranty does not arise if these defects are caused
by external events. These external events shall mean, in particular, a natural disaster, force
majeure or actions of third parties.
N.KO considers the warranty invalid in the event of:
•
improper use of the machine,
•
use contrary to national or international standards,
•
incorrect installation,
•
faulty power supply,
•
serious deficiencies in maintenance,
•
unauthorized modifications and/or interference,
•
use of wrong or other than genuine spare parts and accessories intended for the
respective model,
•
total or partial non-compliance with the instructions,
•
exceptional events, natural disasters and others.
1.4
Identification Data
The identification data of the machine for bevel chamfering are stated on the CE rating plate
attached to the engine case.
