ESS
17
5.
EMERGENCY STOP SIGNAL (mode 1)
The ESS system is equipped with a LED system to assist emergency braking. In case of sudden braking, the
LEDs on the ESS flash for a few seconds.
The sensitivity of the stop signal can be adjusted in 3 different levels:
Low: the stop signal turns on during sudden braking only
Medium
High: the stop signal turns on during slight braking as well
The ESS system is pre-set on HIGH.
To change levels, proceed as follows:
put the system in the
Setting mode
(starting with the ESS system turned off, press the Function
key and keep it pressed for more than 6 seconds, until the LEDs start to flash quickly);
SETTING THE LOW LEVEL: press the Function key and keep it pressed until the LEDs flash once.
Release the key to confirm your choice. The system will now turn off.
SETTING THE MEDIUM LEVEL: press the Function key and keep it press until the LEDs flash twice.
Release the key to confirm your choice. The system will now turn off.
SETTING THE HIGH LEVEL: press the Function key and keep it press until the LEDs flash three
times. Release the key to confirm your choice. The system will now turn off.
The switch from one level to the other occurs
according to the following sequence:
N.B.
: : The emergency stop signal function is active in modes 1, 2, 3.
Summary of Contents for ESS
Page 1: ...EN ...