13
4.3 PULVERIZER MOUNTING PROCEDURE
1.
Place the pulverizer on the ground(or wood block) with blocking to keep the pulverizer
level for installation.
2.
Remove the bucket or other attachment following the manufacturer’s recommended
procedure.
Be careful not to contaminate the hydraulic system by plugging the hydraulic hoses.
3.
With the jaws of the pulverizer facing the excavator, operate the excavator into proper
position, lining the excavator’s arm(second boom) into the top bracket pivot of the
pulverizer.
4.
Pin the excavator’s arm and pulverizer top bracket pivot together.
5. Pick the pulverizer up into a proper position where the second linkage pin can be
inserted. Insert pin.
5.
Connect the hydraulic hoses to the manifolds(or fitting) located on each side of the
Top bracket. Tighten the bolts or cap to the proper torque.
When installation is complete, fully extend excavator bucket cylinder to curl pulverizer.
Check for interference. Contact factory or authorized dealer if any interference occurs.
7.
Lift the boom and slowly try the pulverizer rotate function and pulverizer open and close
function. Watch for hydraulic oil leakage.
Observe flow rate and pressure range(both cylinder and motor) or the warranty will
become void.
