8
Mytek Brooklyn AMP
User’s Manual
9
7. USB
Brooklyn AMP can be controlled by using Mytek Control Panel application. To downlad and install the
software please visit our support page: https://mytekdigital.com/hifi/support/
8. Firmware update Windows and OS X
The current revision of the Brooklyn AMP firmware is shown in the MytekControl „General” tab.
•
The firmware can be updated by using USB2 port and Mytek Control Panel application. It does not
require installed USB2 driver (PC). To download the current firmware please visit:
mytekdigital.com
Follow the steps below to update the firmware:
1.
Download the latest firmware (*.mfb) file from mytekdigital.com
2.
Click „Load firmware file” button and browse to the new firmware file then click „Open”.
3.
Press the „Update” button to confirm uploading the firmware file to device’s memory.
4.
Confirm your choice by clicking „Yes” when warning dialog appears. A progress bar will indicate
when the flash process is finished.
5.
When the update is finished the the AMP will be switched off. To switch it on press the button on
the front panel once.
9.
Technical Specification
Output Power in stereo and bi-amp mode,1kHz @ 8, 4, 2 Ohm: 2x 300W
Output Power in bridge mode, 1kHz @ 8, 4Ohm: 1x 600W
Burst Output Power in stereo and biamp, 1kHz @ 8, 4, 2 Ohm: 2x 500W
Burst Output Power in bridge mode, 1kHz @ 8, 4 Ohm: 1x 1000W
Output voltage in stereo and biamp mode: 70Vp/140Vpp unloaded
Output voltage in bridge mode: 140Vp/280Vpp unloaded
Frequency Response -3dB: 10 Hz - 30 kHz: +0/-0.25 dB
Upper bandwidth @ -3dB for RL = 8 Ohm: 85kHz
Upper bandwidth @ -3dB for RL = 4 Ohm: 65kHz
Upper bandwidth @ -3dB for RL = 2 Ohm: 44kHz
THD+N (1kHz @ 1W): 0.002 %
THD+N (typical): < 0.04 % (20 Hz - 20 kHz, 8 Ohm load, 3 dB below rated power)
Signal To Noise-Ratio: > 121 dB (A-weighted, 20 Hz - 20 kHz, 8 Ohm load)
Input gain control: 23dB (default), 29dB dip switch selectable
Input Impedance: 10 kOhm
Operation Voltage Universal Mains: 85-265V
Protection Circuits: short circuit protection, DC protection,
under voltage protection, temperature protection, overload protection
Dimensions: WxDxH:8.5x9.5x1.74” / 216x241x44mm
Weight: 6lbs / 3 kg
Warranty: 2 years
Summary of Contents for Brooklyn AMP
Page 1: ...Owner s Manual DUAL MONO COMPACT Hi RES POWER AMPLIFIER ...
Page 7: ......
