9
2 - Machine Operation
2.1 - Powering the
Breeze™
Connect power cords by
lining up the female end
of the cord with the male
prongs in the socket on the
machine. Twist clockwise to
lock the cord in place.
Each power cord on the Breeze™ requires a grounded 20
amp outlet. For dual cord machines, plug each cord into
its own 20 amp circuit. The dual circuit indicator light and
tone will activate when this is achieved.
♦
2.2 - Connecting
Hoses
Use the included Cuff-Lynx™
hose connectors to connect
1.5” or 2” vacuum hose to
the Breeze™. Connect the
solution hose via the quick
connect fitting on the front
of the Breeze™ as shown
here.
♦
2.3 - Filling the Solution Tank
The Breeze™ solution tank can be filled up from a bucket
via the opening under the solution tank lid.
♦
2.4 - Switching On the Breeze™ Components
Units Without Heater (BZ-102LX, BZ-102LX-AUTO,
BZ-105LX, BZ-105LX-AUTO)
After a cleaning tool is connected and the solution tank is
filled, switch on the vacuums and the pump in any order.
Units With Heater (BZ-102LXH, BZ-103LX)
In order to avoid vapor locking the unit, the components
should be switched on by following the procedure below
after a cleaning tool is connected:
1. Turn pump switch on. Pull the lever on the cleaning tool
to release air in the line. Hold lever until a steady flow of
water comes out of the wand.
2. Once pump is primed and there is pressure in the
solution line, turn on heater switch and wait a few minutes
for water to heat up.
3. Once water is heated, turn on vacuum and begin
cleaning.
BZ-102LXH Variable
Switch
The variable switch on the
BZ-102LXH model allows
you to switch between the
heater and VACUUM 2.
Follow the same procedure
shown above when heater
will be used.
♦
VAC 1 PUMP VAC 2
HEATER
VAC 1
VAC 2
PUMP
HEATER
3
1 2