PG 5
MyTana M30 JET TER User Manual
During operation
• Tight bends and certain blockages are often more
easily negotiated by rotating or twisting the jetter
hose at drain opening. Once you are through that area,
pull back and pass through several times to ensure
cleaning.
• Once you have opened any blockage(s), pull hose
back very slowly to provide maximum cleaning
to wall of pipe.
• When operating from the high end to low end (most
common) shut off the water flow ball valve on the reel
occasionally. This will allow debris to get ahead of the
nozzle and flush it down the pipe.
• Warm water is effective in cleaning grease and ice
blockages. A cold-hot mix from the tap is adequate,
but do not exceed 140° Fahrenheit. Hotter water can
damage seals in your pump. If you need hot water, use
our HotBox water heater, see next page.
Automatic throttle
• Turn the water flow OFF on the back of the reel to
engage the throttle down. You’ll hear the engine idle
down and the pressure will drop.
• Be sure to feed the nozzle back into the line at least
6 ft before you turn the water flow back on and
re-engage the motor/pressure.
• Don’t operate in throttle down for more than 10-12
minutes or the pump could overheat.
Operating Instructions
1. After checking supply (see above), attach male end of
garden hose to water inlet valve at pump
2. Attach nozzle to end of high-pressure jetting hose.
Finger tighten, do not over tighten.
3. Unlock reel rotation
4. Mark the hose approximately 15 ft back from the
nozzle with electrical tape. Use this tape as a marker
to reduce pressure and shut down the engine when
bringing the hose back out of the drain pipe.
5. Open ball valve on the back of the reel
6. Open water faucet again to prime pump. An equal
amount of water should pass through the orifices of
the nozzle.
7. Push jetter hose into drain up to the marker when
possible (minimally several feet).
u
If you shut the ball valve off before you inserted the
hose into the drain, be sure to re-open the valve
BEFORE starting up the motor.
8. Turn the fuel valve to “on” (by moving lever to the right)
9. Start Motor/Engine
• turn key to “start” and start engine
• the engine has an Auto-choke feature, no need to
adjust the choke lever, see the engine’s owner’s
manual for more information
• it also has automatic throttle, see right
10. Adjust pressure with pressure regulator knob, turning
right to increase pressure, left to decrease.
For normal operation, do not exceed the recommended
3000 psi with the larger 3/8” hose, or 1500 psi with the
smaller 1/8” hose.
11. Start jetting, using pulsation only if needed to promote
forward motion of nozzle and hose.
Pre Operation Checklist
Check for adequate and clean water supply.
Use no smaller than 5/8” garden hose for supply.
• Run water through the hose into a 5 gal.
bucket for 1 minute, it should measure at
least 4.5 gallons
• Flush debris out of faucet and supply hose
• Shut water off again when water runs clear
Make sure water inlet
filter is clean.
Check fluid levels:
— oil in pump
— oil and gas in motor
Check hose for wear or kinks
Check hose reel and all
connections
Select nozzle, make sure orifices
are not blocked or worn to excess
Wear proper clothing,
gloves and eye protection
continued next page
