PG 2
MyTana CBX17 MONITOR / CONTROL BOX User Manual
Controls and Ports
REEL Connect push rod reel
Patch Cord here.
USE CARE, see pg 1.
COUNTER RESET
Resets on-screen footage
counter to zero
REEL SELECT
Selects reel size you are using to
keep footage count accurate.
MSA- = mini reel (100’)
MS11- = mid-sized reel
(150’ or 200’)
MY30 (NGx10/ PGR200) =
large reel (200’)
PGR400 = muni reel (400’)
Hold REEL SELECT button for 3
seconds to switch from feet to
metric (or metric to feet)
TEST PLUG
Test camera head separately from push rod
1. Unplug push rod Patch Cord from REEL port
2. Disconnect camera head from the push rod,
then screw it in to TEST PLUG port to test
POWER
Give the unit 30 seconds to fully boot up
(MyTana logo will show when ready to operate)
Blinking Blue light indicates low battery. It will blink for 5-10 minutes
before battery fails. Plug unit in to standard wall outlet to recharge.
TRANSMIT
Generates 512hz signal at camera head for locating
(has nothing to do with Wi-Fi)
IMPORTANT!
— Use these CONTROL
PANEL buttons
for recording and
working with files.
See next pages.
Damaged Camera Head Connector Ends
For PGR systems: see back page for how to care for the camera
head connection.
For our older systems with pin connectors on the camera head,
we recommend keeping the head attached to the push rod at all
times to avoid accidental damage.
Damaged or Broken Connection Pins
For current PGR systems with a patch cord:
• See how to connect to control box, pg 1.
• The patch cord should NOT be disconnected from the push
rod reel. Check occasionally to make sure it is snug.
Broken Sapphire Window
The sapphire is nearly as hard as diamond;
however it can break with extreme impact,
especially on sharp edges of broken
concrete or clay tile. Using our IceBall,
Snoball or other protective guides greatly
reduces impact to the camera head.
Damaged Pushrod
The camera should not be forced through blockages. This
can cause the wires inside the push rod to become kinked,
buckled or severed. Guides and running water can help
reduce friction as you push the camera through a pipe.
Help prevent
repairs, see our
Care Tips
back cover
Warranty Information Inspection Systems
All products are warranted against defects in material and workmanship for one year from date of purchase.
All products are individually tested prior to shipment. Damage due to negligence, abnormal usage, accidents,
or alteration is not covered by this warranty. Examples of damage not covered by warranty:
LED CONTROL
Full clockwise = full brightness
POWER SOURCE RECEPTACLE
Any 3 prong extension cord can
be used to power unit or recharge
battery. Can be plugged in to
standard wall outlet.