Step 1. Remove the six mounting
screws on side both sides of the radio
Step 2. Pull the radio straight out.
Step 1a. Remove factory radio
and disconnect .
Step 1b. Remove the factory
radio.
Remove the OEM Radio and prepare the Myron and Davis Unit for installation by
following the steps below.
Note
: Inspect all fasteners and brackets for damage. Replace as necessary before the
installation process is started
5 – Remove Factory Radio
Step 3. Relocate this box inside the
dash behind the radio.
Step 4. Remove the vents from the
factory trim bezel
Step 5. Re-install the vents in the
M&D radio bezel.
