EN
MY7010 - User manual
20
Maintenanc e
L ubric ation
: Apply a small amount of white lubrication grease or lube to the holding parts every three months for maintenance.
Tire: Rubber elastic materials are used for our tires. Tires should be changed for the original ones in time if apparently worn or
broken
. Please check the screws. Tighten them If they are loose.
B rake
: Back wheel brakes are used for the scooter. If the brake block is worn, please contact the agency to adjust the tightness;
if it is seriously worn, a new one should be changed for.
B attery
: The batteries our company provides are available for at least 500 times charge. It can be up to 600 times if normally
used. It suggests the aging of battery when the battery is in full charge while the actual mileage is only half of the original one.
A new lithium battery is recommended.
G eneral Tr oubles hooting
When the product doesn't work properly, try to check:
a. whether it is on
b. whether it is still any power left
c. whether the left brake is reset to the original place
d. whether all the sockets are correctly connected
Please contact the manufacturer or the local agency if the product still doesn't work after all the
mentioned points have been checked.
Battery and Charger
Every electric scooter and its fittings equipped with special lithium battery and intelligent charger all have bar codes.
Please do not cross use the charges in case of any danger. Our company is not responsible for it if any problems
happen due to that.
Lithium Battery
Initial use only after it is fully charged.
Charge if the battery is below 2 grids for a better riding experience. Please be sure to get it charged at least once
every three months if unused for a long time (during which it is sufficiently charged). Contact the agency as soon
as possible if charging cannot go on when the battery level is under the protection status.
Charger
The special chargers our company provides are all with timing function. It will cut off automatically when charging is finished.
The product will not be in warranty coverage if destroyed by water, collision, or any other unusual factors.
Charging Instructions
1.Remove the waterproof protective sleeve of charger socket, connect the charger output interface to the scooter
2.Plug the charger into the socket (AC100V-240V)
3.Red light indicates a charging process; it turns to green light when charge is done.
4.Place it in the dry and ventilated places when it is charging.
