© 2016 myPhone.
All rights reserved
myPhone PRIME Plus EN
be unlocked only via entering the PUK code. The terms PIN and PUK pertain to the
documentation received from your mobile operator.
Turning on/off the phone
To turn on the phone press and hold (for about 3 seconds) the on/off/lock key. To turn
the phone off press and hold (for about 3 seconds) the on/off/lock key and select:
[Power off].
Charging the battery
Remember to use only batteries, chargers and cables recommended and approved by
the manufacturer for this model. Using incompatible chargers, cables or batteries can
cause an explosion or damage your device. When the battery is discharged,
appropriate message will be displayed. To continue using the device, you must charge
its battery. After a full discharge of a battery, your device must be charged for at least
a few minutes before turning your device on. Replace or deliver the battery to the
service center in case of any problems with it.
To properly charge the battery you must:
Plug the charger into the device’s microUSB socket. Remember that improper
connection of the charger (USB cable) can damage the unit or AC adapter. Any
damage resulting from improper handling are not covered by the warranty.
Connect the charger to the AC outlet. Once you start charging the battery, in
the upper right corner of the screen the battery icon will change to an animated
lightning symbol, if the device was turned off it should appear as an animation
depicting the level of battery charge.
During the charging process, the device may heat up. This situation is completely
normal and it should not affect the lifespan and efficiency of your device.
When the charge level reaches 100% it means that the battery has been
charged and the process should be finished.
Plug out the charger from the AC outlet and from the device.
In case of any problems with the charging process, both the device and its charger
should be delivered to the manufacturer’s service.
Connection with a computer
To connect myPhone PRIME Plus to a computer with the operating system Microsoft
Windows XP/VISTA/7/8/10/, use the USB cable included in the box as follows:
Connect the USB cable to the multifunctional microUSB socket.
The other end of the cable put into the USB port on your computer.
When the device is connected, the appropriate notification will appear on your
computer screen.
