MyNetFone Mitron MV1, Quick Start Manual, Page: 10 / 11

•
Plug the power cable back into your router and wait about two minutes for
it to start up before continuing.
•
Connect a telephone to the Mitron MV1 Phone port using the RJ11 cable
that adapter provided.
•
If you have a DSL modem that requires PPPoE you need to set up your
PPPoE username and password in the Mitron MV1. Point your browser to:
http://192.168.20.1/
Log in using admin/admin as the username and password.
After setup reboot your MitronMV1.
3. Setup an account at MyNetFone
Following this step if you have not yet entered your details on the MyNetFone
web site.
•
Power up the computer.
•
User a Web browser to go to the MyNetFone web site,
https://www.mynetfone.com.au/shop/service-registration
Follow the instructions to set up your account. During this process,
MyNetFone will verify your system configuration and phone set up.
You will be asked to provide the following information:
•
Enter the serial number and MAC address of your Mitron MV1,
located on the base of the unit.
•
Enter your name and contact information.
•
Select your MyNetFone plan.
Visit: https://www.mynetfone.com.au/residential-voip-
solutions/residential-voip-plan-choices/ for more information.
•
After registration, you will be required to reboot your Mitron MV1.
•
Pick up your telephone handset and listen for a dial tone. If you hear a dial
tone then you have finished installation and may begin making calls. For
dialing instructions, see the helpful Hints on this card. If you do not hear a
dial tone, see Troubleshooting.
•
To check your MyNetFone number dial 151 and select option 2.