Mylex PCI Disk Array Controller Drivers 08P4100, Installation And User Manual

Page: 65 / 100

SCO OpenServer
Manual No. 775079 5-5
5
S
C
O
9. Press the <Enter> key to continue. The system displays several
messages. After the system has completed its installation, you will see
the following message:
NOTICE: Flushing [controller] 0 cache... done
** Safe to Power Off **
- or -
** Press any Key to Reboot **
where [controller] is the base model of the controller.
10. This concludes the installation of SCO UNIX and the Mylex Disk
Array Controller driver. Reboot the operating system from the System
Drive that was just installed.
Installing Additional Mylex Disk Array Controllers
The driver for both the primary controller and any secondary controllers are
installed simultaneously as a part of the previous SCO UNIX installation. No
further procedures are required in order to use additional Mylex Disk Array
Controllers as secondary controllers in the installation.